A35 PIN Pad Stand Setup for SkyTab Kiosk

Description: The Shift4 Kiosk solution includes an A35 PIN pad and Stand. This article outlines the different steps for installing the stand when using Wi-Fi or Ethernet.

---

Note: Reach out to the support team for assistance connecting the device to the network.

Installing Stand for a Wi-Fi Connection

Required Tools and Components

• A35 PIN Pad
• L1400 POS System
• T3400 POS Hub
• Phillips screwdriver
• A35 Stand
• 1 M5 X 8mm long screw
• 1 USB A to C cable

1. If the system is being installed using Wi-Fi, please use the USB A to C cable provided with the PIN Pad and plug it into the back of the A35.
   
2. Align the backplate on the back of the A35 and screw in the M5 X 8mm long screw to secure the backplate to the device.
   
3. Snap the A35 PIN Pad onto the stand and use the sticky back adhesive to secure the device to the countertop.
   
4. Plug the USB A cable into the hub connected to the SkyTab Kiosk station to provide power and configure the device for Wi-Fi connectivity.

Installing Stand for an Ethernet Connection

Required Tools and Components

• A35 PIN Pad
• L1400 POS System
• T3400 POS Hub
• Phillips screwdriver
• A35 Stand
• 1 M5 X 8mm long screw
• 1 USB A to C cable
• 1 USB C “Squid” Cable connection

1. If the system is being installed via ethernet, please use the “Squid” USB C cable.
   
2. Align the backplate on the back of the A35 and screw in the M5 X 8mm long screw to secure the backplate to the device.
   
3. Snap the A35 PIN Pad onto the stand and use the sticky back adhesive to secure the device to the countertop.
   
4. Plug in the USB A to C cable into the “Squid” cable, as seen below.
   
5. Plug the USB cable into the hub to ensure it receives power, or you can use the brick provided to plug into a wall outlet.
6. Plug in one end of the ethernet cable into the red port of the "squid" cable, and the other end into the second ethernet port on the hub.