Ingenico Lane 3000 Ethernet Settings for Micros

Description: Learn to enable and configure Ethernet connectivity on the Ingenico Lane 3000.

---

Note: Verify that the Lane 3000 device is configured for Ethernet mode before proceeding.

1. Plug in the Ingenico Lane 3000 device and wait for it to boot up fully. When the startup is complete, you will see a "This Lane Closed" screen.
   
2. Type in 0001 using the keys on the device to enter the Admin menu.
3. On the Admin menu, select 1- Communication type or use the arrow keys to highlight it, and then press the green Enter button.
   
4. The currently selected communication type will be highlighted. Verify that Ethernet is selected. If not, select 2-ETHERNET or use the arrow keys to highlight it, and then press the green Enter button.
   
5. Press the red Cancel button to leave the menu and select 1-Yes when prompted to save and reboot. When the reboot is complete, you will see a "This Lane Closed" screen.
6. Type in 0001 using the keys on the device to enter the Admin menu.
7. Select 2-Ethernet Parameters.
   
8. Select 1-IP configuration.
   
9. From the IP Configuration menu, ensure that "DHCP activation" is off. Also, verify the IP address of the PIN pad, which will be needed for the UTG device configuration.
   
10. Press the red Cancel button until a "This Lane Closed" screen is displayed.
11. Perform a firmware update.

Internal:

Refer to the Ingenico Tetra UPP (Firmware) Update article to complete the firmware update.