Disconnect and Connect the R15 Onboard Reader Case For SkyTab Glass

Description: Learn how to disconnect and connect the R15 onboard reader, then configure it for SkyTab Glass.

---

Disconnect and Connect the R15 Onboard Reader Case

Let’s begin by getting familiar with the basic steps for managing the R15 onboard reader case. 

1. Make sure the device is powered off, then press against the bottom corners of the case until the bottom of the tablet is fully exposed. Slide the tablet out of the case. If you are only installing the case, you can skip this step.
   
2. To insert the device, slide your SkyTab Glass into the case, top side first, as shown in the image.
    
3. Firmly press down on the bottom corners of the tablet until it is fully housed inside the case.

Once the connection is established, the device will display several notifications related to the SkyTab Glass Magnetic Stripe Reader (MSR) case. The final notification confirms that the connection was successful.

Configure the Device

Visit the Configure the SkyTab Glass article to configure the reader and SkyTab Glass.